Di-Lifter.
Raise, position, and seat dies with controlled lift for fast, ergonomic changeovers.
- Cuts manual handling and ergonomic risk
- Improves changeover times and repeatability
- Flexible: select lift type to suit load and utilities
Di-Clamps .
Fast, reliable clamping in a half turn—no loose hardware, no friction‑based slip.
- Reduces changeover time versus bolting
- Improves safety and repeatability
- Lowers total cost of ownership with hardened contact surfaces
Di-Racks .
Organized, safe storage that puts the next die within reach of the press.
- Cuts the changeover time by pre‑staging near the press
- Improves safety and protects die faces
- Maximizes floor space with vertical storage
Dumper .
Unload bulk railcars quickly to a conveyor with dust control.
- High throughput unloading
- Reduced manual labor
- Integrated dust suppression
Rotary Chute .
Send material to multiple destinations from a single discharge point.
- Flexible destination control
- Reduced spillage vs manual repositioning
- Manual or automated rotation
- Multiple discharge ports
Shuttle .
Bi-directional, positionable discharge from a single conveyor line.
- One conveyor, many discharge points
- Optimizes floor space
- Rail-mounted carriage
- Position feedback and stops
Di-Carts .
Move heavy dies precisely from storage to the press with push/pull positioning.
- Reduces downtime by moving dies while the press finishes the last run
- Improves safety versus manual/overhead handling
- Accurate positioning for first‑time clamping
MS Rails .
Compact roller rails for medium-weight dies and smaller presses.
- Speeds changeovers on lighter tooling
- Improves safety versus manual sliding
- Protects die edges and bolster surfaces
Bolster Extensions .
Load/unload dies outside the press, then slide them into position.
- Safer, more controlled die handling
- Shorter changeover by pre‑positioning outside the press
- Less risk of press/die damage
Shaker (Air/Electric) .
Energy‑efficient vibratory conveying for scrap, parts, and bulk.
- Low maintenance (few wear parts)
- Quiet, efficient operation
- Handles hot/oily material well
Quench Tank .
Automate rapid cooling after heat treatment with precise control and safer handling.
- Faster, consistent cooling
- Reduced manual handling and risk
- Chillers/heat exchangers as needed
- Level controls, low-level alarms
Beltless Magnetic .
Positive control of ferrous scrap and parts—without a belt to wear.
- Low maintenance; no belt to jam or tear
- Enclosed design improves safety
- Permanent magnet arrays
- Coolant/drain management